CARLISLE SYNTEC SYSTEMS -- SURE-SEAL EP-95 SPLICING CEMENT  -- 8040-00N041337
<pre>=====================  Product Identification  =====================

Product ID:SURE-SEAL EP-95 SPLICING CEMENT
MSDS Date:11/20/1991
FSC:8040
NIIN:00N041337
=== Responsible Party ===
Company Name:CARLISLE SYNTEC SYSTEMS
Address:EAST NORTH EXT
Box:617
City:CARLISLE
State:PA
ZIP:17013-0617
Country:US
Info Phone Num:717-245-7000
Emergency Phone Num:800-424-9300(CHEMTREC)
CAGE:0FY91
=== Contractor Identification ===
Company Name:CARLISLE SYNTEC SYSTEMS
Address:EAST NORTH EXT
Box:7000
City:CARLISLE
State:PA
ZIP:17013-0617
Country:US
Phone:717-243-5323
CAGE:0FY91

=============  Composition/Information on Ingredients  =============

Ingred Name:XYLENE  (SARA III). LD50:(ORAL,RAT) 4,300 MG/KG.
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 13.2%
OSHA PEL:100 PPM;150 PPM STEL
ACGIH TLV:100 PPM;150 PPM STEL
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:VM&P NAPHTHA. LD50:(ORAL,RAT) >5,000 MG/KG.
CAS:64742-89-8
Fraction by Wt: 7.5%
OSHA PEL:300 PPM;400 PPM STEL
ACGIH TLV:300 PPM

Ingred Name:HEPTANE
CAS:142-82-5
RTECS #:MI7700000
Fraction by Wt: 6.2%
OSHA PEL:400 PPM;500 PPM STEL
ACGIH TLV:400 PPM;500 PPM STEL

Ingred Name:ISOPROPYL ALCOHOL  (SARA III)
CAS:67-63-0
RTECS #:NT8050000
Fraction by Wt: 5.6%
OSHA PEL:400 PPM;500 PPM STEL
ACGIH TLV:400 PPM;500 PPM STEL

Ingred Name:HALOGENATED BUTYL RUBBER
CAS:63441-14-5
Fraction by Wt: >3%

Ingred Name:HYDROCARBON RESIN
CAS:68132-00-3
Fraction by Wt: >3%

Ingred Name:HYDROCARBON RESIN
CAS:68131-76-0
Fraction by Wt: >3%

Ingred Name:VOLATILE ORGANIC COMPOUNDS
RTECS #:9999999VO
Fraction by Wt: 614% G/L

Ingred Name:SUPDAT:DISCHARGE/OTHER IGNIT SOURCES AT LOCATION DIST FROM
    MATL HNDLG POINT & FLASH BACK. ALL CNTNRS SHOULD BE (ING 11)
RTECS #:9999999ZZ

Ingred Name:ING 10:GROUNDED WHEN MATERIAL IS TRANSFERRED.
RTECS #:9999999ZZ

Ingred Name:OTHER PREC:PRODUCT & SOLVENT VAPORS THAT MAY IGNITE
    EXPLOSIVELY.
RTECS #:9999999ZZ

Ingred Name:VENT:CONCENTRATIONS & KEEP THE PEL BELOW 100 PPM.
RTECS #:9999999ZZ

Ingred Name:TOLUENE  (SARA III). LD50:(ORAL,RAT) 5,000 MG/KG.
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 37.3%
OSHA PEL:100 PPM;150 PPM STEL
ACGIH TLV:50 PPM, S
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:SEE INGREDIENTS.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE:SKIN, EYE, NOSE & THROAT
    IRRITATION ON SHORT TERM EXPOSURE TO LIQUID OR VAPOR. OVEREXPOSURE
    MAY RESULT IN HEADACHE, DIZZINESS, FATIGUE, NAUSEA & LOSS OF
    CONSCIOUSNESS. SOLVENTS MAY BE ABSORBED T HROUGH SKIN IN TOXIC
    AMOUNTS. INGESTIONCAUSES IRRITATION OF GI TRACT. CHRONIC:EXPOSURE
    MAY CAUSE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:REVERSIBLE KIDNEY & LIVER INJURY.
    NOTE:TOLUENE APPEARS ON NAVY LIST OF OCCUPATIONAL CHEMICAL
    REPRODUCTIVE HAZARDS. SEEK CONSULTATION FROM APPROPRIATE HEALTH
    PROFESSIONALS CONCERNING LATEST HA ZARD LIST INFO & SAFE HANDLING &
    EXPOSURE INFO .
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:WHENEVER POSS, REMOVE WORKER FROM SOURCE OF CONTAM. EYE:IMMED
    FLUSH W/RUNNING WATER FOR AT LST 15 MINS. GET MED ATTN. SKIN:IMMED
    FLUSH W/RUNNING WATER & REMOVE CONTAM CLTHG. WASH EXPOSED AREA
    W/SOAP &  WATER. GET MED ATTN. INHAL:REMOVE VICTIM TO FRESH AIR &
    PROVIDE OXYGEN IF BRTHG IS DFCLT. GIVE ARTF RESP IF NOT BRTHG. GET
    MED ATTN IMMED. INGEST:DO NOT INDUCE VOMIT. GET MED ATTN IMMED.

=====================  Fire Fighting Measures  =====================

Flash Point Method:CC
Flash Point:9F,-13C
Lower Limits:0.9%
Upper Limits:12%
Extinguishing Media:IN CASE OF FIRE, USE DRY CHEM, CARBON DIOXIDE/FOAM.
    WATER MAY NOT BE EFTIVE AS EXTING AGENT. WATER FOG/SPRAY
    MAY(SUPDAT)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
    PROTECTIVE EQUIPMENT . THIS PROD CONTAINS SOLVENTS THAT ARE
    DANGEROUS FIRE & EXPLO HAZS WHEN EXPOSED TO HEAT/FLAME.
Unusual Fire/Explosion Hazard:EXTREMELY FLAMM. STORE & USE AWAY FROM
    ALL SOURCES OF HEAT, FLAME/SPKS. DO NOT SMOKE WHILE APPLYING. VAPS
    ARE HVR/AIR & MAY TRAVEL ALONG GROUND/MAY BE (SUPDAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. AVOID
    BREATHING VAPORS. USE NIOSH/MSHA APPROVED SCBA IN ENCLOSED AREA.
    VENTILATE AREA. CONTAIN & REMOVE W/INERT ABSORBENT MATERIALS &
    NON-SPARKING TOOLS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE AWAY FROM ALL SOURCES OF HEAT,
    FLAME/SPARKS. DO NOT SMOKE WHILE USING. HNDLG EQUIP MUST BE
    GROUNDED TO PVNT SPARKING. HANDLE W/NON-SPARKING TOOLS.
Other Precautions:KEEP OUT OF REACH OF CHILDREN. KEEP CNTNRS COOL, DRY
    & STORE AWAY FROM ALL SOURCES OF HEAT, FLAME & SPKS. KEEP CNTNRS
    TIGHTLY CLSD & STORE W/ADEQ VENT. DO NOT PRESSURIZE, CUT,
    WELD/GRIND CNTNRS/EMPTY  CNTNRS WHICH MAY CNTN RESIDUAL (ING 12)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR MUST BE USED IF
    PEL IS 100 PPM OR ABOVE.
Ventilation:DO NOT USE IN ENCLSD AREAS W/OUT PROPER EXPLO-PROOF VENT.
    GEN & LOC EXHST VENT MUST BE SUFFICIENT TO CONTROL VAP(ING 13)
Protective Gloves:HYCRON GLOVES.
Eye Protection:ANSI APRV CHEMICAL WORKERS GOGGLES (FP N
Other Protective Equipment:INDUS SHOES, LONG SLEEVES & LONG TROUSERS TO
    PROT FEET & SKIN FROM ADHESIVE CONT. PROT SKIN CREAMS/EMOLLIENTS
    USEFUL.
Work Hygienic Practices:WASH W/SOAP & WATER BEFORE EATING OR DRINKING.
    LAUNDER CONTAMINATED CLOTHING.
Supplemental Safety and Health
% VOLAT:69.7(WT). EXTING MEDIA:BE USED TO PROVIDE SMOTHERING EFT ON
    FIRE & TO COOL FIRE-EXPOSED CNTNRS & SURROUNDING COMBUSTS. DO NOT
    USE SOLID STREAM OF WATER BECAUSE IT CAN SCATTER & SPREAD FIRE. EX
    PLO HAZ:MOVED BY VENT & IGNITED BY PILOT LIGHTS, OTHER FLAMES,
    SPKS, HEATERS, SMOKING, ELEC MOTORS, STATIC (ING 10)

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>180F,>82C
Melt/Freeze Pt:M.P/F.P Text:-0F,-18C
Vapor Pres:6.7-45
Vapor Density:2-3.9
Spec Gravity:0.880
Evaporation Rate &amp; Reference:1.9-8.3 (N-BUAC=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK LIQUID W/STRONG HYDROCARBON ODOR.
Percent Volatiles by Volume:SUPDAT

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, ACIDS, BASES.
Stability Condition to Avoid:HEAT, SPARKS & FLAMES, IGNITION SOURCES.
Hazardous Decomposition Products:TOXIC GASES OR VAPORS, SUCH AS CARBON
    MONOXIDE, CARBON DIOXIDE OR OXIDES OF NITROGEN MAY BE RELEASED IN A
    FIRE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF I/A/W ALL LOCAL, STATE & FEDERAL
    REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.