MEAD PAPER, FINE PAPER DIVISION -- FAN-APART ADHESIVE FOR TRANS/RITE CARBONLESS PAPER,S-4  -- 8040-00N065773
<pre>=====================  Product Identification  =====================

Product ID:FAN-APART ADHESIVE FOR TRANS/RITE CARBONLESS PAPER,S-4
MSDS Date:07/17/1990
FSC:8040
NIIN:00N065773
=== Responsible Party ===
Company Name:MEAD PAPER, FINE PAPER DIVISION
Address:SOUTH PAINT ST
Box:2500
City:CHILLICOTHE
State:OH
ZIP:45601
Country:US
Info Phone Num:614-772-3111
Emergency Phone Num:614-772-3111
Preparer's Name:ANN H CRONE
CAGE:83215
=== Contractor Identification ===
Company Name:MEAD PAPER, FINE PAPER DIVISION
Address:SOUTH PAINT ST
Box:2500
City:CHILLICOTHE
State:OH
ZIP:45601
Country:US
Phone:614-772-3111
CAGE:83215

=============  Composition/Information on Ingredients  =============

Ingred Name:1,2-PROPANEDIOL
CAS:57-55-6
RTECS #:TY2000000
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:ACRYLIC LATEX
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:ETHYL ALCOHOL (ETHANOL)
CAS:64-17-5
RTECS #:KQ6300000
Fraction by Wt: <10%
OSHA PEL:1000 PPM
ACGIH TLV:1000 PPM

Ingred Name:METHANOL (SARA 313) (CERCLA)
CAS:67-56-1
RTECS #:PC1400000
Fraction by Wt: <1%
OSHA PEL:200 PPM, S
ACGIH TLV:200PPM/250STEL, S
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:ACETIC ACID, ETHYL ESTER; (ETHYL ACETATE) (CERCLA)
CAS:141-78-6
RTECS #:AH5425000
Fraction by Wt: <1%
OSHA PEL:400 PPM
ACGIH TLV:400 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:2-PENTANONE, 4-METHYL-; (METHYL ISOBUTYL KETONE) (SARA 313)
    (CERCLA)
CAS:108-10-1
RTECS #:SA9275000
Fraction by Wt: <1%
OSHA PEL:100 PPM
ACGIH TLV:50 PPM/75 STEL
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:HEPTANE
CAS:142-82-5
RTECS #:MI7700000
Fraction by Wt: <1%
OSHA PEL:500 PPM
ACGIH TLV:400 PPM/500STEL

Ingred Name:WATER
CAS:7732-18-5
RTECS #:ZC0110000
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:ETHYL ACRYLATE (SARA 313) (CERCLA)
CAS:140-88-5
RTECS #:AT0700000
OSHA PEL:25 PPM, S
ACGIH TLV:5 PPM/15 STEL, A2
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:FRAGRANCE; (BALSAM FRAGRANCE)
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:HYGIENE PRACT: TO REMOVE FROM CLOTHING ONCE IT IS DRIED.
    RECOMMEND LAUNDERING WHILE ADHESIVE IS STILL WET.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALATION: CONCENTRATED VAPORS
    MAY CAUSE SLIGHT SENSORY IRRITATION. INGESTION: SINCE THESE
    FORMULAS CONTAIN LATEX AND SOLVENTS, AVOID INGESTION! SKIN:
    REPEATED OR PROLONGED CONTACT MAY CAUSE D EFATTING OF THE SKIN.
    AVOID SKIN CONTACT! CHRONIC: CHRONIC CONTACT W/SOLVENTS MAY RESULT
    IN DEVELOPMENT OF DERMATITIS.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:ITCHING, DRYING OR CRACKING OF SKIN. COUGHING
    AND SORE THROAT FROM CONCENTRATED VAPORS. ODOR MAY CAUSE NAUSEA FOR
    SOME PEOPLE.
Medical Cond Aggravated by Exposure:PRIOR RESPIRATORY OR SKIN DISORDERS
    MAY BE AGGRAVATED BY EXPOSURE TO SOLVENTS.

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE FROM EXPOSURE AND TREAT SYMPTOMATICALLY
    AND SUPPORTIVELY. IF DIFFICULTIES PERSIST, SEE MD. INGESTION:
    INDUCE VOMITING AND TREAT SYMPTOMATICALLY. SKIN: WASH WITH SOAP AND
    WATER. EYES : FLUSH WITH LARGE AMOUNTS OF WATER, OCCASIONALLY
    LIFTING EYELIDS UNTIL ALL SIGNS OF MIXTURE ARE GONE (APPROXIMATELY
    15 MINUTES). GET MEDICAL ATTENTION.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:132F,56C
Extinguishing Media:USE FOAM, CARBON DIOXIDE, OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
    PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:EXCESSIVE HEAT MAY CAUSE DISRUPTIVE
    PRESSURE IN CLOSED CONTAINER.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ABSORB SPILL WITH INERT MATERIAL (SAND,
    VERMICULITE, PAPER) AND TRANSFER TO CONTAINERS FOR DISPOSAL. REMOVE
    SATURATED CLOTHING AND WASH AFFECTED SKIN AREAS WITH SOAP AND
    WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:KEEP CONTR CLOSED WHEN NOT IN USE TO
    AVOID LOSS OF SOLV. STORE AWAY FROM SOURCES OF IGNIT. AVOID
    FREEZING/HIGH TEMPS THAT DEGRADE ADHESIVE QUALITY.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NOT NORMALLY REQUIRED. USE NIOSH/MSHA APPROVED
    RESPIRATOR WITH ORGANIC VAPOR CARTRIDGE OR CANISTER WHERE SOLVENT
    VAPOR CONCENTRATIONS MAY EXCEED LEVELS LISTED IN INGREDIENTS
    SECTION.
Ventilation:GENERAL OR LOCAL VENTILATION TO CONTROL ODOR OR VAPOR
    CONCENTRATIONS TO BELOW LEVELS LISTED IN INGREDIENTS SECTION.
Protective Gloves:REC POLYETHYLENE/RUB GLOVES TO (SUP DAT)
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:NOT NORMALLY REQUIRED. ANSI APPRVD EMER
    EYEWASH & DELUGE SHOWER .
Work Hygienic Practices:USE NORM GOOD INDUS HYGIENE PRACT. DO NOT SMOKE
    IN AREAS WHERE COMBUST/FLAM MIX ARE IN USE. NOTE: LATEX IS
    DFCLT(ING 10)
Supplemental Safety and Health
PROT GLOVES: PVNT SKIN CONT W/SOLV COMPONENT. CUSTOMER IS RESPONSIBLE
    FOR DETERMINING SUITABILITY OF GLOVES FOR WORK ENVIRON & OTHER
    SOLVS/CHEMS THE EMPLOYEE MAY NORM BE EXPOSED TO. REPLACE GLOVES AT 
    FIRST SIGNS OF DETERIORATION (HARDENING, CRACKING,
    SOFTENING/SWELLING).

==================  Physical/Chemical Properties  ==================

Melt/Freeze Pt:M.P/F.P Text:30.0F,-1.1C
Spec Gravity:1.0 (H*2O=1)
Solubility in Water:DISPERSIBLE
Appearance and Odor:MILKY WHITE LIQUID, WITH BALSAM ODOR
Percent Volatiles by Volume:<10

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE.
Stability Condition to Avoid:NONE.
Hazardous Decomposition Products:BURNING WILL GENERATE DENSE SMOKE,
    CARBON MONOXIDE AND CARBON DIOXIDE GASES.

====================  Disposal Considerations  ====================

Waste Disposal Methods:INCINERATE OR LANDFILL, ACCORDING TO APPLICABLE
    LOCAL, STATE, AND FEDERAL REGULATIONS FOR COMBUSTIBLE LIQUIDS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.